SAP-13

Model	SAP13
Micron Rating	5µm nominal
Chlorine Reduction	> 97.50%
Turbidity Reduction:	>94.65%
Scale Reduction:	> 85.0%
Temperature	20 (+/- 3) °C
Flow Rate	2 LPM
pH	7.5 (+/- 0.05)
Model Dimensions (diameter x length)	7.0cm x 23.2cm

Description

Operating Parameters:

Minimum Operating Pressure	80 kPa
Maximum Operating Pressure	800 kPa
Nominal Flow Rate	2.00 LPM
Maximum Operating Temperature	38°C

General Installation / Operation / Maintenance Requirements:

Flush new cartridge for 5 minutes before first use.
Replace cartridge when rated capacity is reached or when flow slows.
Install in compliance with state plumbing laws.
Do not use with water that is micro biologically unsafe or of unknown quality without adequate disinfection before or after the cartridge. Activated carbon filters are not designed to remove virus.or bacteria.
Actual performance results may vary based on the level of organic contaminants in the influent water, changes in pH and upon other conditions that may be encountered during actual use.
The performance of this cartridge has been verified and substantiated in accordance with AS/NZS 3497 and AS/NZS 4348 for reduction of chlorine.

Verified Claim Reductions:

The Saipol filter models listed above have been tested and certified under AS/NZS 3497, AS/NZS 4348 and relevant NSF/ANSI Standards listed in Clause 2 for reduction of chlorine. The performance of these cartridges has been verified and substantiated as the test data summarised below indicates. These substances may not be in your water.

Substance	ASNZ-4348 minimum reduction requirement	Average Influent Concentration	Maximum Effluent Concentration	Minimum Percent Removal	Average Effluent Concentration	Average Percent Removal
Chlorine	75% (Class 1)	1.99 mg/L	0.06 mg/L	97.20%	< RL	97.50%
MCL – Maximum Contaminant Level mg/L – milligrams per Litre (1mg/L = 1 part per million) (a) National Health and Medical Research Council Australian Drinking Water Guidelines. (b) United States Environmental Protection Agency Safe Drinking Water Act.		Testing Conditions Flow Rate: 2 LPM pH: 7.5 (+/- 1) Pressure: 400 kPa Temp: 23°C

Substance

ASNZ-4348 minimum reduction requirement

Average Influent Concentration

Maximum Effluent Concentration

Minimum Percent Removal

Average Effluent Concentration

Average Percent Removal

Chlorine

75% (Class 1)

1.99 mg/L

0.06 mg/L

97.20%

< RL

97.50%

MCL – Maximum Contaminant Level
mg/L – milligrams per Litre (1mg/L = 1 part per million)
(a) National Health and Medical Research Council Australian Drinking Water Guidelines.
(b) United States Environmental Protection Agency Safe Drinking Water Act.

Testing Conditions

Flow Rate: 2 LPM
pH: 7.5 (+/- 1)
Pressure: 400 kPa
Temp: 23°C

Permissible Claims (where applicable):

Treatment Type	Description	Category	Performs
Microbiological status
Bacteriostatic	Will stop bacteria increasing but will not remove them unless Category II(a) is passed	I	N/A
Microbiological treatment
Bacteria removal	Will remove or inactivate bacteria	II(a)	N/A
Virus removal	Will remove or inactivate viruses	II(b)	N/A
Protozoa removal	Will remove or inactivate Cryptosporidium and Giardia. Will not remove or inactivate bacteria and viruses unless Category II(a) and Category 11(b) are passed	II(c)	N/A
Aesthetic effects
Turbidity and particulate removal	Reduces cloudiness	III	N/A
Taste and Odour reduction	Reduces tastes and odours	IV	Verified
Chemical treatment
Chemical contaminant reduction	Decreases certain chemicals (specify)	V	N/A
Other
Other treatment types not captured in Categories Ito V	No verification methods are defined (specify) scale	VI	Non-verified

SAP product line extensions

Saipol Standard series

Triple Action - Sediment, Scale, Taste and Odour
Choice of 5 or 0.5µm
Available across all Zip models
Watermarked

Saipol C-series

1µm sediment
Double Action - Sediment and Scale
Available across all Zip models
Watermarked

Saipol A-series

0.22µm (hollow fibre)
Double Action - Sediment and Scale
Independently media tested across a panel of bacteria and viruses

Saipol's A-Grade filter media has been independently media tested for the following bacteria:

Pseudomonas Diminuta
Klebsiella terrigena
Polio virus 1
Rota virus
Cyst
Routella terrigena
fr coliphage
MS2 coliphage Cyst

C & A Grade are carbon free. C & A Grade filters are available only on selected Filter Series.

The details provided are true and correct at the time of publishing. Saipol Technologies however reserves the right to make changes or products improvements as required without notice. Saipol Technologies does not make any representation that any of its products have commensurate performance characteristics to other brand filters that they are designed to replace. No specific or implied performance claims are made unless otherwise stated. All Saipol SAP-01 through to SAP-13 series cartridges carry the Australian Standard 3497 Watermark.